Wind Generator Purchase Page
Designed by Ralph Hillman
Quick Product Links:
Quick Support Links:
AIR X Tower KitGuyed towers are the standard for simple and durable wind installations. These towers are designed for easy tilt-up to simplify erection. All parts are threaded, so no welding is required.
Use with 2" schedule 40 steel pipe (not supplied.) The AIR 403 requires a 1-1/2" pipe for the last 5 feet (not supplied.)
Use with 2" schedule 40 steel pipe (not supplied.) The AIR 403 requires a 1-1/2" pipe for the last 5 feet (not supplied.)
AIR X STOP SWITCH
This high capacity stop switch allows you to stop the turbine for inspection, and provides a general safety stop switch to stop the blades from spinning. This high-capacity double-pole double-throw switch is a must for the complete, safe operation of this powerful generator.
This high capacity stop switch allows you to stop the turbine for inspection, and provides a general safety stop switch to stop the blades from spinning. This high-capacity double-pole double-throw switch is a must for the complete, safe operation of this powerful generator.
Home of the Sun Tracker "Patent Pending"
12 volt 200 Watt Chinook W200 24 lbs
$700.00
24 volt 200 Watt Chinook W201 24 lbs
$700.00
$79.00
The robust Chinook 200 wind turbine is powerful for its size. Has good performance at many wind speeds. Easy to install on 1.5” schedule 40 steel pipe 1.9" outside diameter. Cut in speed is at 8 mph (350 rpm), makes 85 watts at 18 mph and 200 watts at 28 mph. 80 mph maximum. Body is stamped aluminum. The quiet running blades are injection molded. Innovative direct drive brushless alternator is 3-phase axial flux permanent magnet design. Includes separate controller with dump load. Turbine is 26” long. Nose cone is 9” diameter. 3 year factory warranty.
The robust Chinook 200 wind turbine is powerful for its size. Has good performance at many wind speeds. Easy to install on 1.5” schedule 40 steel pipe 1.9" outside diameter. Cut in speed is at 8 mph (350 rpm), makes 85 watts at 18 mph and 200 watts at 28 mph. 80 mph maximum. Body is stamped aluminum. The quiet running blades are injection molded. Innovative direct drive brushless alternator is 3-phase axial flux permanent magnet design. Includes separate controller with dump load. Turbine is 26” long. Nose cone is 9” diameter. 3 year factory warranty.
$359.00
$525.00
The Mallard LW is built with the same sturdy construction as our Mallard 800E but is specifically designed for areas with lower winds than our 800E. Use in areas with wind speeds of 5-60MPH. It outperforms the 800E in winds up to 25MPH. It will continue to charge in higher winds also. The construction of the Mallard LW also makes it quieter, which will make your neighbors happy. These blades have a span of 5 foot. The base of each blade is 9 ". The Mallard LW is best in areas with winds speeds of 5-25MPH. The Mallard LW contains a powerful magnet to produce great power. 10MPH winds push the blades to start turning. Once this unit is going it will continue to turn in winds as low as 5MPH.
SWEA 1000 Watt Wind Turbine Kit
$1,225.00